Themo is shipped with 10k Ohm temperature sensor and whenever possible this sensor should be used. The correct sensor is selected during Configure and Setup. In order to change the previously selected sensor, go through the following:

  1. Connect your computer/phone to the same local network where Themo is connected
  2. Open Themo web user interface. Go to “Device Info” page of your Themo.
  3. See Themo IP address. Open new web page with Themos IP address.
  4. Themo configuration page opens. By clicking with the arrow go to the “Temperature sensor” page. See instructions here. on how to choose temperature sensor. Click arrow to the end and click “Save”

For best result use Google Chrome or Mozilla Firefox browsers.